Technical Support

Need help?

 

Error 5000 while installing Endpoint Protection

Information applies to:

Products
Endpoint Protection
Endpoint Protection Plus

Situation

The following error might occur while installing Endpoint Protection:

NOTE: The error message can refer to any stages of the installation process. The image above shows error 5000 when establishing a connection with the server.

Cause

This error message can be caused by either of the causes below:

  • Using an outdated installer. The installers are progressively updated on the web server. When access to old versions is removed, the installers are no longer valid.
  • Loss of Internet connection or connection to the client’s internal network during the installation process.
  • Even if you have Internet access, you may not be able to access some of the URLs necessary for PCOP to work correctly. This generally occurs when a firewall or a proxy server is used that does not allow access to these addresses.

Solution

  • Outdated installer

    If you are using an installer which had been previously downloaded locally, delete it and download a new one from the Endpoint Protection web console. Check that the issue is resolved with the new installer.
  • No Internet connection

    1. Check the Internet connection is fully operative.
    2. Check the other computers on the network are detected.
    3. Make sure there is no firewall blocking the network traffic.
    4. Check that the computer´s date is correct.
    5. Restart the computer.
    Once you have restarted the computer, the Endpoint Protection installation process will be automatically launched again.
  • No access to some of the URL addresses necessary for PCOP to work correctly

    Make sure you can access the URLs necessary for PCOP to work correctly from your browser. If you cannot access them, check your settings and fix it.
Help nº- 20140701 505000 EN
ALWAYS ONLINE TO HELP YOU TWITTER FORUM
ALWAYS ONLINE TO HELP YOU TWITTER FORUM